National Instruments PXIe-7902 Getting Started Manual - page 6
2.
In the Configuration pane, expand Devices and Interfaces to see the list of installed
devices. Installed devices appear under the name of their associated chassis.
3.
Expand your Chassis tree item. MAX lists all devices installed in the chassis. Your
default device names may vary.
Note
If you do not see your module listed, press
installed modules. If the module is still not listed, power off the system, ensure
the module is correctly installed, and restart.
4.
Record the device identifier MAX assigns to the hardware. Use this identifier when
programming the PXIe-7902.
5.
The MAX self-test performs a basic verification of hardware resources. To self-test a
module in MAX, right click the module and select Self-Test.
If any module fails the self-test, refer to the Troubleshooting section of this document.
Accessing Sample Projects
NI LabVIEW Instrument Design Libraries for High Speed Serial Instruments includes sample
projects to help you get started designing for the PXIe-7902.
1.
Launch LabVIEW.
2.
Select Create Project.
3.
In the Create Project dialog box, select High-Speed Serial and select a sample project
for your device.
4.
Click Next.
5.
Configure the Project Name, Project Root, and File Name Prefix (Optional) fields.
6.
Click Finish.
PXIe-7902 Front Panels
The following figure shows the available signals on the PXIe-7902.
6
| ni.com | PXIe-7902 Getting Started Guide