National Instruments PXIe-7902 Getting Started Manual - page 8
Operating System
Description
Windows 10/8.1
Right-click the Start button, and select Device Manager.
Windows 7
Select Start»Control Panel»Device Manager.
5.
If you are using a PXI or PXI Express controller, verify that a National Instruments
entry appears in the System Devices list. Reinstall NI LabVIEW Instrument Design
Libraries for High Speed Serial Instruments and the module if error conditions appear in
the list. If you are using an MXI controller, right-click PCI-to-PCI Bridge, and select
Properties from the shortcut menu to verify that the bridge is enabled.
What Should I Do if the Module Fails the Self-Test?
1.
Restart the system.
2.
Launch MAX, and perform the self-test again.
3.
Power off the chassis.
4.
Reinstall the failed module in a different slot.
5.
Power on the chassis.
6.
Perform the self-test again.
Troubleshooting
If an issue persists after you complete a troubleshooting procedure, contact NI technical
support or visit
ni.com/support
.
Where to Go Next
Refer to the following figure for information about other product tasks and associated
resources for those tasks.
8
| ni.com | PXIe-7902 Getting Started Guide