National Vacuum Equipment 5314 Owner's Manual & Operating Instructions - Preservation
5314 Blower | 17
www.natvac.com | 800.253.5500
Preservation
Keep all intake, exhaust and ballast port coverings in place to prevent debris
or liquids from entering blower. Reapply rust preventative oil to all metal
parts, including the compression chamber every 6 months or more frequent-
ly if the relative humidity is greater than 80%.
While in storage, rotate the shaft three to four revolutions every two weeks
to keep gears coated in oil.
Before installing a blower that has been stored for any length of time, remove
the intake and exhaust covers and inspect the rotors and cylinders to insure
the absence of rust. In addition, remove the oil fill plug on drive oil tank and
inspect the gear for absence of rust.
·
Use a rust preventative oil with a flash point over 400
°F
·
Dispose of used rust preventative oil according to local
regulations
INSTALLATION
Rotation and Airflow
Diesel Engine Precautions
·
DO NOT OPERATE BLOWER WITH A DIESEL ENGINE RUNNING
AT LOW RPM’S AS TORQUE PULSES CAN CAUSE ROTOR LOBE
CONTACT AND DAMAGE TO THE BLOWER.
When directly driving the blower with Diesel engine, bring the engine up to
operating RPM and then engage the blower via the clutch. Be sure to start
the blower under no load conditions.
Use caution when using a Diesel engine that is significantly oversized for the
operating point of the blower. Doing so can result in an inertial mismatch,
excess torsional vibrations at low RPM’s and blower lobe contact.
For more information Diesel torsional vibrations, see the technical report by
LoveJoy titled New Twists to Diesel Vibration at
www.lovejoy-inc.com
.
Direct Coupling
Recommended Equipment
Use of a jaw in shear style coupler is recommended.
Description
MANUFACTURER
NVE P/N
MFG P/N
Blower Flange
Magnaloy
424-M500-178
M50012816
Solid Coupler
Insert
424-M500-HTI
M570H5
Drive Flange
424-M500-14T
M500A1412
Blower Jaw
LoveJoy
424-225-187
L225X1 7/8
Spider (Urethane)
12417
Ring
Drive Jaw
424-225-
Installation and Alignment
Slide the couplers onto the blower shaft and prime mover shaft using
appropriate tools.