NATURSCHALLWANDLER ETERNITA Assembly And Installation Instructions - page 2
Page 2
4.) Selecting and connecting the audio crossover
You may select between two frequency crossover points for
the mid and high-frequency range of ETERNITA, which differ
in their sound pattern and dynamics. For medium-sized and
large living rooms and other indoor rooms we recommend
selecting “highpass 2 – home area regular power”. This
crossover is controlled from the two bottom connectors on
the rear terminal (Fig 3).
For very large indoor rooms, such as conference rooms and
halls, or for using the device as a PA sound system or
outdoor events, we recommend
selecting the “highpass 1
large area high power“ setting, which is controlled by the two
upper connectors on the rear terminal (Fig 4).
To connect your selected frequency crossover, please use
the four supplied cable links, two of each are provided with a
red mark (plus pole) and two each are provided with a black
mark (minus pole). Using these cables, bridge-connect your
selected mid/high-frequency speaker to the connector of the
system bass loudspeaker (Fig. 5).
Plug the connector of a red cable bridge into the red (middle)
receptacle on the rear terminal (bass). Depending on the
selected crossover, plug the other connector of the cable
bridge EITHER into the red (highpass 2) OR the upper red
(highpass 1) receptacle on the terminal (Fig. 3 or Fig. 4).
Now plug the connector of a black cable bridge into the black
(middle) receptacle on the rear terminal (bass). Depending
on the selected crossover, plug the other connector of the
cable bridge EITHER into the lower black (highpass 2) OR
into the upper black (highpass 1) receptacle of the terminal
(Fig. 3 or Fig. 4).
NOTE
:
Always make sure to select the same frequency crossover
for both loudspeakers!
Do not use the cable bridges to connect highpass 1 and
highpass 2! (Fig. 6)
Fig. 3
Fig. 4
Fig. 5
Fig. 6