NATURSCHALLWANDLER ETERNITA Assembly And Installation Instructions - page 3
Page 3
Now both channels of the loudspeaker bass are connected
(bridged) to one of the two frequency crossover points.
Please repeat the entire procedure with your second speaker
column.
You may change between the two crossover configurations
by removing the
connector from “highpass 1” ON BOTH
speakers and inserting it into the receptacles of “highpass 2”,
and vice versa. The (bass) connectors in the middle remain
unchanged for both frequency crossover configurations
(Fig. 3 or Fig 4).
ATTENTION
:
Make sure to switch off the amplifier before performing any
changes on the wiring!
5.) Cable connections from amplifier to ETERNITA
Your NSW is provided with 2 x 6 metres of loudspeaker cable as a
standard. On one side of each cable there are two banana plugs in
red (plus pole) and black (minus pole). The other end has bare
wires provided with a protective sleeve (Fig. 7).
The plus cable is marked with a red line along its length; the
minus cable is not colour-coded.
NOTE
:
-
Please leave your amplifier switched off when
connecting the loudspeaker cables.
-
Pull the protective sleeves from the bare wire ends of the
loudspeaker cables and remove the plastic caps from the
banana plugs.
NOTE
:
Make sure that the colour coding of the connecting terminals
matches the colours of the connecting cables (red to red, bare
to black).
-
Now guide the loudspeaker cable with the red plug into the
middle opening on the right-hand side. Insert the cable with the
black plug into the middle opening on the left-hand side
(Fig. 8).
BARE WIRES
BANANA PLUG
PROTECTIVE SLEEVE
CABLE CONNECTION
AMPLIFIER 1