Nav TV NTV-KIT586 Installation Manual - page 12
BHM
03/09/15
NTV-DOC204
Agreement
:
End user agrees to use this product in compliance with all State and Federal laws. NAV-TV Corp. would not be held liable for
misuse of its product. If you do not agree, please discontinue use immediately and return product to place of purchase. This product is
intended for off-road use and passenger entertainment only.
12 |
P a g e
RAM MULTI-CAM Operation
Rear Camera Operation: Placing the vehicle in to reverse will automatically display
any connected camera. This image will take precedence over all other images
unless the ‘Turn Rev’ feature is set to ON in NAVTV Settings (this setting
makes Turn Signal Cameras overtake Reverse image).
Force Rear Camera: To force rear camera, press and hold radio ‘BACK’ button for 2
seconds. To exit forced rear camera, press and release radio ‘BACK’ button. Note:
forced rear camera is only supported on aftermarket cameras.
Force Front Camera: To force front camera, press and hold both radio ‘SCREEN OFF’
& ‘BACK’ buttons together for 2 seconds. To exit forced front camera, press and
release radio ‘BACK’ button.
Auto-Front PDC Camera: With ‘PDC’ enabled in NAVTV Settings (ON or OEM*), the
connected front camera will display any time the following is true:
a. The vehicle is in Drive
b. The vehicle is traveling < 7mph
c. The connected front parking sensors sense an obstacle
The radio will return to the factory image after the Parking Sensors no longer sense
an intrusion, or the vehicle reaches about 7mph.
*OEM Sensor-switching not available with this release. This feature is coming soon.
Activate Aux Video mode: To activate the AUX screen, press and hold radio ‘SCREEN
OFF’ button for 2 seconds. To exit AUX mode, press and release the ‘BACK’ button.
If using AUX video mode for an A/V source, the RCAs located on the Plug &
Play T-Harness must be opened up with an AVSW (KIT224, not included with
MULTI-CAM). See Page 5, Step 4.
CIM: Hold
(3 sec) to
activate
Force front camera: Hold both
‘SCREEN OFF’ & ‘BACK’(2 sec)
AUX: Press & hold
(2 sec) to activate
Force rear camera:
Press & hold (2 sec)
2 seconds
2 seconds
2 seconds