Nav TV NTV-KIT586 Installation Manual - page 13
BHM
03/09/15
NTV-DOC204
Agreement
:
End user agrees to use this product in compliance with all State and Federal laws. NAV-TV Corp. would not be held liable for
misuse of its product. If you do not agree, please discontinue use immediately and return product to place of purchase. This product is
intended for off-road use and passenger entertainment only.
13 |
P a g e
MULTI-CAM Operation Continued
Activate CIM (Control in Motion): To activate CIM for
factory navigation, press and hold the ‘Volume’ button for 3
seconds (CIM will disable automatically after 3 minutes).
This function will also keep the Cargo Camera enabled for 3
minutes, and will reset upon every key cycle.
NOTE: Activating the CIM function will NOT bypass video in
motion at this time, if equipped.
Turn Signal Cameras: To display TSCs, simply use the turn
signals as you would normally and the connected image will
display either all the time (while in drive), or only after 25,
30 or 35 mph respectively, depending on what was set in
MULTI-CAM programming.
If the user desires TSC images to take precedence
over the reverse, this option must be enabled in
NAVTV Settings (Turn Rev = ON).
Additionally, the user may use a “bump method” to
view the TSC quickly. Toggling the turn signal level
quickly (just enough to engage the bulb) will display
the TSC image for 3 seconds.
Cargo CAM: When Cargo CAM is set to ‘ON’ or ‘FIX’ in the
NAVTV Settings menu, the OEM Cargo Cam menu will be
emulated on the radio. This will allow the option for forcing
an added Cargo/Trailer/Baby camera (or displaying both on
the main screen). Press the ‘Cargo Camera’ button located
in the ‘Controls’ tab on the main radio screen to display the
camera connected to the Cargo CAM RCA.
If the user has and desires both OEM cameras
(Cargo CAM and Reverse CAM) to display on the
8.4” screen, additional installation is needed, see
Pg. 6, Step 5. The Cargo CAM option must be set to
‘FIX’ for this setup to work properly.
After activated, while the vehicle is in motion, the
OEM Cargo Camera will time out in about 5
seconds. For viewing the Cargo Camera for a longer
duration (3 mins), activate the CIM function. See
below.
3 seconds
If using this feature, you MUST perform a
full CAN reset (after programming) before
the menu will display!