Nav TV NTV-KIT586 Installation Manual - page 14
BHM
03/09/15
NTV-DOC204
Agreement
:
End user agrees to use this product in compliance with all State and Federal laws. NAV-TV Corp. would not be held liable for
misuse of its product. If you do not agree, please discontinue use immediately and return product to place of purchase. This product is
intended for off-road use and passenger entertainment only.
14 |
P a g e
FAQs
Q1. I can’t get into programming mode.
A1. Turn off the vehicle and remove the key. Close all points of entry and use the remote to lock
the vehicle. Wait approx. 5 minutes without opening or disturbing the vehicle. Unlock and cycle the
ignition to the ‘RUN’ position. Make certain that the cluster is in FM radio mode before you begin
programming; and no errors are displayed (door open, etc), otherwise the cluster information might not
display. Hold down the “MUTE” button until you see the display options post on the cluster.
Q2. When I try to force (front, rear) camera, nothing happens.
A2. Make certain you’ve enabled the options you want to use in the NAVTV settings mode and
that you scrolled to the end and selected ‘EXIT’ (or it will not save).
Q3. I hear no audio when my auxiliary source is playing on screen.
A3. Verify that the audio RCAs are connected properly to the AVSW.
Q4. Everything works properly, but when an audio source is connected to the 3.5mm audio jack,
there’s no audio.
A4. Make sure the audio RCAs are connected together on the Plug & Play harness.
Q5. When I place the vehicle into reverse, I get a black or blue screen.
A5. Make sure the camera is getting sufficient power and the RCA is connected to the proper
yellow RCA on the 24-pin harness.
Q6. The camera image is displayed properly when the vehicle is in reverse, but there’s only a black or
blue screen when the camera is forced.
A6. Make sure the camera power is not connected to the reverse lamps. Camera power needs to
be connected to an accessory wire (cigarette lighter). If the camera is OEM, forcing it to display in any
gear is not supported.
Other MULTI-CAM Notes:
When multiple cameras are connected, the MULTI-CAM will clear back to the factory image
after 3 cameras have been forced in succession. This is normal. I.E: If you had AUX mode
displayed on screen, turned the left turn signal on (which will display), then rolled up to an
obstacle which forced the front camera, placing the vehicle into park will then display the
factory image (will not return to AUX image automatically).
Cluster feedback only displays while programming (NAVTV Settings).
Cargo Camera usage will only display for about 8 seconds when in motion, then will time out
(this is a factory limitation). Activating the CIM feature will retain this image for 3 minutes if
desired.
When setting Cargo Cam to ‘ON’ or ‘FIX’, you must let the vehicle perform a full CAN reset, after
programming, before the menu will display properly.