Navigon 8410 premium edition User Manual - page 18
User’s manual NAVIGON 8410 PREMIUM EDITION | 8450 LIVE PREMIUM EDITION
- 18 -
Before you begin
Note: Insert the USB connector securely in the corresponding USB
sockets!
Caution! Be sure to refer to all the safety information in chapter
"Important safety information" on page 12.
Note: It takes approx. 3 hours to charge the device when the battery is
flat.
A fully charged battery enables up to 3 hours of use depending on the
device configuration.
TMC antenna
The navigation device has an integrated TMC receiver. The TMC
antenna is integrated in the car charger cable. Once the car charger
cable is connected, the device can receive current traffic messages. If
required, it can change your route dynamically, e.g. in order to avoid a
traffic jam.
2.6.4
Preparing the NAVIGON Live module for use
This section is relevant for you only if you have purchased a
NAVIGON Live
module for your navigation device.
Selecting the right car charger cable
You have purchased a bundle comprising a navigation device and a
NAVIGON Live module:
The bundle comes with the right car charger cable. Use this cable.
You have purchased the NAVIGON Live module as an add-on to an
already existing navigation device:
The adapter in your existing charger cable may not have enough power
to supply both devices (the navigation system and the NAVIGON Live
module) with electricity.
Caution! Use only the car charger cable which was supplied with the
NAVIGON Live
module!
The car charger cable supplied with the NAVIGON Live module is
powerful enough for both devices.
Connecting the NAVIGON Live module to the navigation device
1. Connect the cable of the NAVIGON Live module to the USB socket
of the navigation device used for the power supply.