Navmanu Qube 2 Installation Manual - page 12
Manual is about: GPS TRACKING AND FLEET MANAGEMENT SOLUTIONS
of
15
Qube 2 | Installation Manual
13
7 Fault
Finding
Fault
Resolution
Power LED fails to light
Check that the +12 / 24 V wire has permanent power connected to it
Check the DB15 I/O connector is correctly connected, and the securing
screws are hand tightened onto the Qube 2
GPS LED fails to light
Ensure that the antenna is up the correct way, and has a clear view of as
much of the sky as possible
Check the antenna connectors are correctly connected, and hand
tightened onto the Qube 2 connectors
It may take up to 15 minutes for a fi rst GPS fi x after the unit has been
shipped un-powered to a new location
CELL LED fails to light
Check the antenna connectors are correctly connected, and hand
tightened onto the Qube 2 connectors
Check if the area has CELL coverage