Navmanu Qube 2 Installation Manual - page 5
Qube 2 | Installation Manual
6
3 Quick Install – 3-Wire Basic Tracking
3.1 Power
Connection
Wire Colour
Function
Description
Red
+12/24V
Main Power Connection – connect to fused supply
Pink
Ignition
Positive input from vehicle when the key is in the IGNITION
position (not the accessory position). This signal must remain
on DURING starting of the vehicle – connect to fused supply
Black
GND
Vehicle ground / chassis connection
Note: Please individually insulate any bare ends that are not connected
3.2 Recommended
Mounting
Under the dash, or under the driver or passenger seat
In the boot / trunk area
Where it is not excessively hot
Where it is dry
Where there is not excessive vibration
Should allow MDT/M-Nav connection
Should allow the diagnostics LED’s to be seen
Should allow suffi cient clearance to plug and unplug while mounted
3.3 Status LED Indicators
LED
Display State
Normal Operation
Description
Power
On
P
Power ON, Unit awake
Slow Flash
Sleep mode
Off
No Power – Note: the Qube 2 should
always be powered
GPS
On
P
GPS fi x
Off
No GPS fi x
CELL
On
P
Data connection to cellular network
Off
No data connection
•
•
•
•
•
•
•
•
Tax Disk Antenna
Red = +12/24V Battery
Pink = ignition “ON”
(NOT Accessories)
Black = Ground