Navmanu Qube 2 Installation Manual - page 6
Qube 2 | Installation Manual
7
4 Installing the Qube 2 in a Vehicle
4.1 Location
and
Mounting
Install the Qube 2:
Under the dash, or under the driver or passenger seat
In the boot / trunk area
The chosen location should:
Allow for later connection of the MDT or M-Nav
Be dry
Not have excessive vibration
Not be excessively hot
Allow the antennas and cabling to easily connect to the Qube 2
Allow the diagnostics LED’s to be seen
Allow suffi cient clearance to plug and unplug while mounted
Mount the unit using the supplied self-tapping screws and washers, placed through the slots in
the side rails. If a different mounting format is required, the mounting rails may be turned over or
removed by unscrewing the front cover and sliding the rails out to change their orientation.
Connect the antenna cables to the correct connectors. Both the Cellular connector (BNC/TNC)
and the GPS (SMA) are screw on connectors, which should be hand tightened only. Connect the
DB15 connector to the socket and hand tighten the two locking screws.
Ensure all cables are secured out of the way, so they will not be damaged, walked on, or have
other articles placed on them.
IMPORTANT NOTICE
Before you begin, ensure that drilling will not damage the vehicle’s structure, wiring or
equipment
Ensure the Qube 2 cables, mounting screws etc will pose no hazard to the occupants of
the vehicle
•
•
•
•
•
•
•
•
•
•
•