Naxa NAS-3046 Instruction Manual - page 7
Manual is about: Neckband Speaker with Bluetooth
of
14
www.naxa.com
Page 7
Using the USB/AUX In-
put Connector
Connect devices without Bluetooth
®
by using the AUX
connection. The included 3.5mm adapter combination
cable is required to make this connection.
1. Use the 3.5mm plug of the included combination AUX
cable to connect the device’s headphone or line-out
jack to the DC5V/AUX connector of the speaker.
2. Turn on the device and the speaker. Lower the vol-
ume on both.
3. Set the device volume to 80% of its maximum and
then start playback.
4. Press and hold
to gradually increase the vol-
ume of the speaker to a comfortable level.
L
L
Use the connected AUX device to control
all functions in AUX mode. The speaker can
only be used to adjust the volume.