Naxa NAS-3049 Instruction Manual - page 8

Page 8 

Naxa Electronics

Using the USB/SD 

Card Player

Your  speaker  can  play  MP3  files  from  USB  memory 

sticks or SD memory cards. Connect USB memory 

sticks to the USB port [3]; load SD memory cards in the 

SD card slot [2]. Turn the speaker on, then press MODE 

to set the speaker mode to USB or SD.

When the speaker is in USB or SD mode:

To do this...

...do this

Start, pause, or resume audio 

playback

Press PLAY/PAUSE.

Skip to the previous track

Press PREV/VOL–

Skip to the next track

Press NEXT/VOL+

Decrease the volume level

Press and hold PREV/VOL–

Increase the volume level

Press and hold NEXT/VOL+

Switch the audio source mode

Press MODE.

⚠

⚠

Do not remove USB sticks or SD memory 

cards while the speaker is on. Doing so may 

damage the speaker system or memory 

card/USB stick.  

FAILURE TO FOLLOW THESE INSTRUCTIONS 

MAY RESULT IN DAMAGE TO THE SPEAKER 

SYSTEM AND VOID THE WARRANTY.

Using the AUX Input 

Connector

Connect devices without Bluetooth

®

 by using the AUX 

connection. A 3.5mm stereo patch cable is required to 

make this connection.

1.  Use the included AUX cable to connect the device’s 

headphone or line-out jack to the LINE IN (AUX) 

connector (10) found on the back of the speaker.

2.  Turn on the device and the speaker. Lower the vol-

ume on both.

3.  Press MODE [7] to set the active source of the 

speaker to AUX.