Naxa NPB-267 Instruction Manual - page 14
Page 14
Naxa Electronics
⚠
L
Bluetooth works best within 10 meters.
If the connection fails, the PAIR indicator will
keep flashing.
To disconnect an Bluetooth device from the
boombox, press and hold the / button
until the PAIR indicator flashes blue.
To learn more about how to use the Blue-
tooth audio function of your device, please
refer to the instructions provided by the
device manufacturer.
AUX-In Operation
1. Connect the audio source to the boombox. Use a
3.5mm audio patch cable (not included) to connect
the 3.5mm output jack of the audio source to the
3.5mm AUX Input jack [14] found on the front of the
boombox.
2. Prepare the boombox. Press the FUNCTION button
[5] to select “AUX” mode, then lower the volume
level (turn the Volume dial [15] counter-clockwise).
3. Prepare the audio source. Start playback on the
device, then set the volume level of the device to
approximately 80% of its maximum.
4. Adjust the final volume on the boombox. Rotate
the Volume dial [15] to set the volume to a com-
fortable level.
⚠
L
Use the audio source to control playback
(e.g., stop, play, next). Use the boombox to
control the volume.