CLOCK/ALARM SETTING
Alarm
Setting the Alarm
1. Press the
STANDBY
button (#3) to turn the unit off.
2. Press and hold the
AL1 (#13) or AL2 button (#14) until the display begins to blink, and then
release the button.
3. Press the
Tune +/- buttons (#11, 10) to adjust the hour.
Note the PM indicator will light when the hour is set in the PM.
4. Press the
AL1 or AL2 button (#13, 14).
5. Press the
Tune +/- buttons (#11, 10) to adjust the minute.
6. Press the
AL1 or AL2 button (#13, 14).
7. Press the
Tune +/- buttons (#11, 10) to switch between Buzzer, Radio and CD. The display
will indicate the following:
rAd for Radio, bU for Buzzer, and Cd for CD.
8. Use the
Vol+/- buttons (#14, 13) to adjust the volume of the alarm, except when set to
Buzzer.
9. Once the set alarm time is reached, the alarm will sound.
3.
To set the other alarm, follow the above steps and choose the alarm not currently set.
Snooze and Alarm Reset
After the alarm sounds:
Press the
Snooze/Dimmer button (#16) to delay the alarm for several minutes.
OR
Press the
STANDBY
button
(#3) to turn the alarm off until the set alarm time is reached again.
Disabling the Alarm
Press the
AL1 or AL2 button (#13, 14).until the indicator is no longer lit. The alarm will turn off
and will not sound.
AUX IN
Using the Audio Input
Requires a 3.5mm audio cable (not included).
1. Connect a 3.5mm audio cable to the
AUX Input (#21) on the side of the unit and the audio
output on an audio device.
2. Press the
STANDBY button (#3) to turn the unit on.
3. Press the
Function button (#8) to switch to Aux In mode.
4. Use the native controls on the connected device to play your audio through the unit.