NCD NC200 Installation Manual - Introduction
Floppy Disk Drive Installation
1
Floppy Disk Drive Installation
Introduction
These instructions describe how to connect your new floppy disk drive to your
Network Computer (NC). Connection is made to the parallel port on the NC.
When you are using the WinDD ICA client, this drive provides you with PC file
storage and retrieval capability at your NC.
With NCBridge 3.2 (or higher), there is a new local floppy manager client that
allows the user to transfer files between a UNIX host and the local floppy disk.
Operation of this client is described later in this document.
Before you begin installation, check the contents of the kit to be sure that you
have everything and check to be sure you have a Parallel Port installed in your
NC. Then turn to the installation procedures that begin on page 2.
Kit Contents
The Floppy Drive kit includes the following:
• One Floppy Drive
• One AC Power Adapter
• One AC Power Cord
• One Interconnect cable
• These installation instructions