NCD ThinSTAR 200 Installation Manual - Options
ThinSTAR 200 Installation Guide
7
Options
The following options are available for the
NCD
Thin
STAR
200:
Video monitor
Memory
Mounting bracket
and security
device
If your monitor is
DDC
2.0 compliant, you get the largest
desktop area supported by the monitor at a refresh rate of
at least 85 Hz, up to a maximum of 1024x768 pixels. If
your monitor is not
DDC
2.0 compliant, you get the
NCD
Thin
STAR
200’s default desktop area of 800x600 pixels at
75 Hz.
This option allows you to mount the terminal to a wall or
the side/underside of a desk. You can secure the terminal
to either the stand or the mounting bracket.
If you are using the optional mounting bracket and/or
security device, refer to the installation instructions that
are included with the option.
The
NCD
Thin
STAR
200 has a
SIMM
slot for an optional
EDO SIMM
. 8
MB
, 16
MB
, and 32
MB EDO SIMM
s are the
only
SIMM
s that will work in the slot. You can order your
NCD
Thin
STAR
200 either with no
SIMM
or with an 8
MB
SIMM
in the slot.
You can remove an existing 8
MB SIMM
and replace it with
a 16
MB
or a 32
MB
SIMM or insert either an 8
MB
, a 16
MB
, or a 32 MB
SIMM
in the empty slot at any time. The
maximum memory that the
NCD
Thin
STAR
200 can map
is 32
MB
. If you use a 32
MB EDO SIMM
in the slot, the
terminal does not use the built-in 8
MB EDO
memory.
If you buy your
SIMM
from
NCD
, refer to the installation
sheet that is included with the
SIMM
. Otherwise refer to
the
NCD
Thin
STAR
200 System Administrator’s Guide for the
SIMM
specifications and installation procedure