NCE Mini-Panel Instruction - page 13
Default values for memory locations
Location 0 - 3 Cab bus address, 2-63 are OK
Location 1 - 5 Debounce timer (normally doesn’t ever need change)
Location 2 - 0 Clear all 8 memory locations for an input when programming 1=don’t
Location 3 - 0 Input number at/above which command string memory is continuous
Location 4 - 0 Input number at/above which commands will not execute if input active
Location 5 - 0 Input number than can be used to interrupt “wait” commands
Location 6 - Unused (Software version 201 when read via USB - CV7)
Location 7 - Unused (Manufacturer 11 when read via USB - CV8)
Locations 8 through 255 - 0
Warning: This product contains chemicals known to the State of
California to cause cancer, birth defects or other reproductive harm.
Warranty
This product is fully factory tested and warranted against manufacturing defects for a
period of 1 year. As the circumstances under which this product is installed can not be
controlled, failure due to installation problems can not be warranted. This includes
misuse, miswiring, operation under loads or voltages beyond the design range of the
product.
For warranty or non-warranty repair/replacement send the product (an any payment, if
required) to:
NCE Warranty Center 82 East Main St. Webster, New York 14580
05240230
05240230
The terms Silent Running, Power Pro, PowerCab , ProCab, Switch-It the NCE logo with “Power of DCC” slogan are trademarks of
NCE Corporation. The distinctive shape of the ProCab when used with a thumbwheel speed control and LCD display is a
trademark of NCE Corporation.
Last revised: 22 July 2008 Page 13