NcTech ISTAR User Manual - page 14
Reset Button or On/Off Switch
If you experience problems your camera will be equipped with
either an On/Off switch or Reset button to shutdown the camera.
Using the On/Off switch
1. Locate the On/Off switch on the rear of the camera behind the
rubber port panel.
2. To switch off, slide the switch and wait for 2 seconds before
switching the unit back on.
3. Tap the 4 corners of the touch screen to start up the camera.
Using the Reset button
1. Locate the Reset button on the rear of the camera behind the
rubber port panel.
2. Press a pointed object through the hole until you hear a long
audible beep.
3. On hearing the beep, release the button.
4. You will hear a 2nd audible beep and the iSTAR logo will flash on
screen confirming the camera has shut down successfully.
5. Tap the 4 corners of the touch screen to start up the camera.
6. If the reset does not solve the issue then disconnect and
reconnect the battery.
If problems persist, disconnect the power cable (if connected)
and disconnect and then reconnect the battery.
IMPORTANT: Do not put the camera in its protective
case when switched on. This will create excessive
heat as the foam acts as an insulator. Damage from
misuse in this way may not be covered by warranty.
Contact
This Users Manual is current as of March 2014. For information on the camera’s compatibility with
any accessories or third party hardware or software, contact your reseller or NCTech direct.
NCTech Limited
20-22 Braid Road , Edinburgh, Scotland , UK
Registered in Scotland no. SC389309
Support Portal
For technical support, please visit our support portal: support.nctechimaging.com
On the portal you can access iSTAR FAQs, request technical support and much more besides.
+44 (0) 131 202 6258
@NC_Tech /nctechltd
www.nctechimaging.com
iSTAR User Manual /
v1.2
/
13
10. Troubleshooting