NEAR 6XL Installation And Use Manual - page 7
3
Panel Description
1. Speaker Terminals - Connects to speaker loads. One set for each amplifier section. Accepts up to
#10 AWG wire or spade lugs for speaker system connections.
2. Ground Terminal - Provides convenient access to earth ground.
3. HIGH-Pass/LOW-Pass
Filters-
High-Pass rolls off frequencies below 85 Hz (2nd order). Low-Pass
rolls off frequencies above 85 Hz (2nd order). In addition, Low-Pass enables subwoofer preset EQ, one
per channel.
4. Channel Level Controls - Continuously variable channel level controls, one per channel.
5. STEREO/MONO Select Switch - Allows Input A and Input B to sum and then “Y” to each output channel.
6. Fan Exhausts - Cooling air outlets for independent, variable speed cooling fans. One per channel.
7. Line Cord - AC mains line cord.
8. Automatic Sleep Mode - Allows the unit to automatically put itself into sleep mode when there has
been no input signal for more than 3 minutes. In sleep mode, the amplifier’s idle power is greatly
reduced. The amplifier immediately and noiselessly returns to its full-powered state when a signal is
detected at an input.
9. High-Impedance Unbalanced Inputs - RCA Type connectors allow for easy installation and provide
convenient connections to high-impedance unbalanced inputs. One per channel.
10. High-Impedance Balanced Inputs - XLR female connectors allow for easy installation and provide
convenient connections to high-impedance balanced inputs. One per channel.
6XL Rear Panel