Nearus NU-100-USB2PT-B User Manual - page 3
Product Manual - NU-100-USB2PT-B & NU-300-USB2PTZ-B
© 2014 Nearus™ | PG. 3
Installation
Best Practices:
• For conference rooms where the audience will be seated around a table, install the camera below the display, near
eye-level for seated participants. For larger training rooms or classrooms, mounting above or beside the display
may be preferred.
• Typical mounting height for a conference room camera is between 30 and 65 inches AFF.
• Proper lighting is critical for image quality. Backlighting from outside windows should be avoided and proper
foreground lighting is highly recommended.
• It is recommended to have the electrical or general contractor install a double gang junction box at the desired
camera height during the project’s construction.
Wall Mount Installation
1. Install a double gang junction box in the wall at the desired location.
2. Pull the necessary field wires (USB 2.0 extender, control wires, and
power wires) to the double gang j-box.
3. Thread the field wires through the L-bracket’s wire access hole and
secure the L-bracket to the j-box using the 4 provided screws.
4. Mount the camera to the L-bracket using the 2 short screws from the
underside of the camera and bracket.
5. Connect the USB 2.0 cable, power connection, and control wire to
the back of the camera.
6. Connect USB 2.0 cable to the PC and select the ‘Nearus Camera’ as
the video device in the software.
Dual Gang
Mounting Screw
Holes
Camera Mounting
Screw Holes
Wire Access
Hole
Tripod/Ceiling Mount Installation
The included threaded adapter was designed to attach the base of the camera to a standard
1/4-20 UNC threaded rod or a standard camera mount - such as a tripod.
Attach the threaded adapter to the camera using two small screws (included), then attach
this assembly to the threaded rod or a camera mount.
Align
Align