Nearus NU-100-USB2PT-B User Manual - page 4
Product Manual - NU-100-USB2PT-B & NU-300-USB2PTZ-B
PG. 4 | © 2014 Nearus™
1. Connect your local laptop via USB 2.0 Cable & a VISCA to RS-232
adapter.
2. Confirm the COM port by going to Control Panel > Device Manager
> Ports (or push the Windows key + Pause/Break). Expand the Ports
tree, and locate the camera’s port number at the end of the line item,
or right click the Port, and click Properties and locate the port number.
3. Next, download the Nearus Camera Control Software, and begin
setup. Follow the basic installation steps to include your name,
company name, and desired application location.
4. Once the install is complete, match the COM port on the top right of
the HD Camera Debugger software to the COM port established in
Device Manager.
5. Now you are ready to control the camera!
Basic Functionality
Now that the camera is set up with the HD Camera Debugger software, you may test some of the basic features.
1. Pan and tilt the camera using the directional buttons.
2. Adjust the speed of the camera’s movement by sliding the tab to the
desired speed.
3. To *Zoom in or out, press Tele (In) or Wide (Out).
Note: Some features within the HD
Camera Debugger software are
designed for future use.
*Zoom feature NU-300-USB2PTZ-B only
4. Point the camera toward the desired viewing area, type in a number
in the “Num” field, and press “Set”.
5. Press “Call” with the previously entered number in the “Num” field,
and the camera will return to the original viewing area.
Optional Camera Software Install
If you are not using software of your own, you may use the optional software available on the product page, located
under the Support tab, labeled “Nearus Camera Control Software”.