NEC powermate dt Disassembly - 8. Removing The Motherboard
Disassembly and Reassembly - 9
Fig. 14: Unlocking the switch/LED assy
3. Carefully pull the assy and the cables away.
Note
When reassembling the switch/LED assy take care that it is
put back into its original position, i.e. with the switch at the left side of
the LEDs.
8. Removing the Motherboard
To remove the motherboard first open the chassis (see the
section Opening the Chassis) than do as follows:
1. Disconnect all cables from the motherboard and from all
add-on cards that are installed.
2. Remove the add-on cards (if any are installed).
3. Remove CPU and memory modules (refer to the
motherboard documentation for information on how to
remove memory modules and CPU).
4. Remove the screws holding the motherboard as shown.
Fig. 15: Removing motherboard screws
5. Carefully take the motherboard out of the chassis.
B