North Star Design SAPPHIRE Operating Manual - page 10
1
.
STBY Standby on/off
2
.
0-9 Press these buttons to select a specific track on the disc. For track 10 and above, the
second digit of the number must be pressed within one second. Then press PLAY button to
change rapidly.
3
.
AUDIO When the Player is in STOP, with a SACD inside, press to change layer, from
SACD to CD and from CD to SACD.
4
.
SOUND MODE When the Player read a SACD disc, pressing this button, you can select
6ch or 2ch tracks.
5
.
STOP – OPEN/CLOSE Pressing this button you stop the reproduction; pressing for more
than one second, the button made the OPEN/CLOSE function.
6
.
PAUSE On/off.
7
.
PLAY
8
.
NEXT TRACK Pressing once you select the next track; keeping pressed the button you
select forward searching function; 5 searching speed are available pressing the next track
button.
9
.
PREVIOUS TRACK Pressing once you select the previous track; keeping pressed the
button you select backward searching function; 5 searching speed are available pressing
the previous track button.
10
.
REP Press this button once and the current track will be repeated. The display will show
«RPT TRACK». Press the button again, and it will repeat all the tracks. The display will
show «RPT DISC». Press again and the display will show «RPT OFF».
11
. A/B Repeat a segment of the disc/track. Press the button once to mark the start Press it
again at the end of the desired sequence. The selected area will play continuously until the
STOP button is activated.
12
.
TRACK The Player will reproduce the first 6 seconds of each track.
13
. SHUF Tracks will be played in a random order.
14
.
DISPLAY Pressing this button you can select the display
brightness; Mode 1, Mode 2,
Normal
15
.
TIME Normally the display show the time from incoming of the track. Pressing once the
display will show the time remaining at the end of the track. Pressing again the display will
show the time from the incoming of the disc. Pressing again the display will show the time
remaining at the end of the disc.
Replacing remote control batteries
Replace used batteries opening the battery compartment cover. Lift the cover off, and insert a fresh
set of batteries. Be careful to follow the + and – polarity indications at the bottom of the battery
compartment. Battery: 2 x CR2025: 3Volts.