North Star Design SAPPHIRE Operating Manual - page 7
7 REMOTE SENSOR RECEIVER
8 OPERATE LED INDICATOR
The
Operate LED
show the operating mode of your SACD Player:
Glows blue
when the SACD Player is in Operation mode.
Off
the SACD Player is in Stand-by.
9 STAND-BY LED INDICATOR
The
Stand-by LED
show the operating mode of your SACD Player:
Glows red
when the SACD Player is in Stand-by.
Off
the SACD Player is ready to use.
If the SACD Player will not turn on, you may want to check the
rear panel AC
mains switch
, your AC connections, or have your dealer inspect the rear panel fuses.
10 DISC TRAY
11 OPEN/CLOSE PUSHBUTTON
12 PLAY/PAUSE PUSHBUTTON
13 STOP PUSHBUTTON
14 DISC SELECTION PUSHBUTTON
When the Player is in STOP, with a SACD inside, press to change layer, from SACD
to CD and from CD to SACD.
Rear Panel
Caution!
Switch Off the SAPPHIRE SACD PLAYER when you need to connect or disconnect any cables.
15 AC MAINS SWITCH
This switch may be used to disconnect the power supply from the AC mains without having to
actually unplug the SACD Player from the wall outlet. If you plan to be away for an extended period,
or have any other reason to turn the SACD Player completely off, you may use the
AC mains
switch
.
16 AC MAINS FUSES
Two slow-blow 500mA (220-240V), 800mA (100-120V) fuses are located inside a small drawer in
the AC main inlet. If you suspect that your AC fuse have blown, disconnect the SACD Player from
the AC mains and contact your North Star Design dealer for assistance.
17 AC MAINS INLET
Standard IEC power cords is provided with the SAPPHIRE SACD Player. High quality power
cords will improve the sonic performances; ask your North Star Design dealer.
The North Star Design SAPPHIRE SACD Player has been safety-tested and is designed for
operation with a three-conductor power cord. Do not defeat the “third pin” or earth ground
of the AC power cord.