North Star Fluxio Operating Manual - page 10
Ph Submenu
0 degree output phase (Normal mode)
180 degree output phase
NOTE:
In Flt and Ph menu you cannot exit from setup mode. You have to return to others menu
(A0..2, AH0..2,d0..2)!
Optimal setting selection.
The
Fluxio
Analog gain need to be set to allows a right listening level for a volume fews dB below the
reference 0,00dB.
After you have selected one of the settings, press the knob again for a few seconds.
You return to the stand-by mode again.
KNOB CONTROL
When
Fluxio
is in Stand-by:
–
with a small pressure of the knob the DAC enter in operative mode. On frequency/input display
appears
“nsd”
written.
–
with a pressure of some seconds the DAC enter in SETUP mode. The last configuration appears
on setup and subsetup display.
.
When
Fluxio
is in Setup:
–
moving the knob to the right/left you scan the different configurations appearing on setup display.
For some configuration (AH0..2,Flt,Ph) is provided a submenu setup in which you can enter with a
small pressure of the knob. At this point you can observe the selected option blinking on subsetup
display. When you confirm with a small pressure of the knob the option appears again stable on
display.To exit from setup press again some seconds the knob.
When
Fluxio
is operative:
–
press one time the knob to enter in input mode. Move the knob to right/left for changing input. On
frequency/input display appears the selected input in a stable mode, then press again
one time to confirm. When on the chosen input there is connected a source, you can rotate the
knob to right/left for increasing/decreasing volume (not in direct mode). If there is no signal on
selected input a rotation of knob has no effect in variation of volume.
To return in Stand-by press the knob for some time.
NOTE: If you are in input mode you can't return in Stand-by. Therefore a long press of the knob
has only the effect to confirm the displayed input.