North Star Fluxio Operating Manual - page 7
Front Panel
1 HEADPHONE OUTPUT CONNECTOR
Plug here your headphone. Refer to SETUP section to correctly select the headphone output level
2 STAND- BY LED INDICATOR
The
Stand- by LED
shows the operating mode of your converter:
Glows red
when the DAC is in Stand-by.
Off
the DAC is ready to use.
If the DAC will not turn on, you may want to check the
rear panel AC
mains switch
, your AC connections, or have your dealer inspect the rear panel fuses.
3 VOLUME/SETUP DISPLAY
Three digit display shows the attenuation level in operative mode and the available configurations in
the setup mode
4 REMOTE SENSOR
5 VOLUME/INPU T/SETUP KNOB
In Stand-by – pressing the knob for some seconds the DAC enter in SETUP mode (see the SETUP
section). Pressing newly the knob the DAC will back in stand-by status (see the KNOB CONTROL
section).
In Operative mode – turn left/right the knob to decrease/increase the volume. Pressing the knob for
some seconds the DAC enter in INPUT MODE. Turn left/right the knob to decrease/increase the input.
Pressing again to exit from INPUT MODE(see the KNOB CONTROL section).
6 FREQUENCY/INPUT/SUBSETUP DISPLAY
In setup mode on the three digits appear the available options for one configuration if provided(see
the SETUP section). In operative mode appears the selected input and when there is signal the
sampling frequency of audio stream.
Rear Panel
Caution!
Switch Off the
Fluxio
when you need to connec t or disconnect any cables.
7 COAX INPUT (COAX 1)
Use this input to connect the DAC to the digital output of a source (CD transport, DAT tape, DVD
player), using a 75 Ohm digital cable provided with RCA connectors (not shipped with the
equipment).
8 COAX INPUT (COAX 2)
Use this input to connect the DAC to the digital output of a source (CD transport, DAT tape, DVD
player), using a 75 Ohm digital cable provided with RCA connectors (not shipped with the equipment).