North Star Fluxio Operating Manual - page 9
Danger! Potentially dangerous voltages and current capabilities exist within the Fluxio DAC,
when connected to the AC mains. Do not attempt to open any portion of the DAC cabinet.
There are no user-serviceable parts inside the Fluxio DAC. All service of this product must be
referred to a qualified North Star Design dealer or distributor.
SETUP
In
STAND-BY
mode, press the knob for some seconds - you will enter in SETUP mode.
There are 11 different setups for the
Fluxio
:
A 0 Analog gain 1Vrms @0dB Headphone output OFF
A 1 Analog gain 2Vrms @0dB Headphone output OFF
A 2 Analog gain 4Vrms @0dB Headphone output OFF
AH0 Analog gain 1Vrms @0dB Headphone output ON
AH1 Analog gain 2Vrms @0dB Headphone output ON
AH2 Analog gain 4Vrms @0dB Headphone output ON
AH0 Submenu
Lo 1.0Vrms Headphone output
Mid 1.5Vrms Headphone output
Hi 2.0Vrms Headphone output
AH1 Submenu
Lo 2.0Vrms Headphone output
Mid 3.0Vrms Headphone output
Hi 4.0Vrms Headphone output
AH2 Submenu
Lo 4.0Vrms Headphone output
Mid 6.0Vrms Headphone output
Hi 8.0Vrms Headphone output
NOTE:
By setting Lo/Mid/Hi you have the same basic submenu configuration for AH0/AH1/AH2.
d 0 Analog gain 1Vrms @0dB Headphone output OFF
DIRECT (no volume control)
d 1 Analog gain 2Vrms @0dB Headphone output OFF
DIRECT (no volume control)
d 2 Analog gain 4Vrms @0dB Headphone output OFF
DIRECT (no volume control)
NOTE:
By setting d0/d1/d2 should be used connecting an external preamp!
Flt Submenu
Hi high slope of digital filter
Lo low slope of digital filter