North Storm NS-10W-AC User Manual - Operation Introduction
9
Drain Hose
OPERATION INTRODUCTION
Before starting operations in this section:
1) Find a place where there is power supply nearby.
2) As shown in Fig.5 and Fig.5a, install the exhaust hose,
and adjust the window position well.
3) Insert the power cord into an grounded AC115V/60Hz socket;
4) As shown in Fig. 6, connect water pump drain hose well
(only for using heating model).
5) Press the ON/OFF button to turn on the air-conditioner.
FIG. 5
FIG. 6
FIG. 5a
Please make sure the unit has been standing upright for at least 2 hours before
starting or using.
10
OPERATION INTRODUCTION CONT.
Maximum
Cooling
Minimum
Cooling
Maximum
Heating
Minimum
Heating
DB/WB( 0F )
95/75
64/54
80/---
45/---
Before using
Notice: Operation temperature range:
Check up whether the exhaust hose has been mounted properly.
Cautions for cooling and dehumidifying operations:
● When using functions on cooling and dehumidifying, keep an interval of at least
3 minutes between each ON/OFF.
● Power supply meets the requirements.
● The socket is for AC use.
● Do not share one socket with other appliances.
● Power supply is AC115V, 60Hz
Cooling Operation
● Press the “Mode” button till the “Cool” icon appears.
● Press the “ ”or“ ”button to select a desired room temperature. (62-90 F0)
● Press the “Fan Speed” button to select wind speed.
Dehumidifying Operation
● Press the “Mode” button till the “Dehumidify Indicator Lamp” blinks
● Set the selected temperature to current room temperature minus
2F0. (62-90F0)
● Set the fan motor to LOW wind speed.
Fan operation
● Press the “Mode” button till the “Fan” icon appears.
● Press the “Fan Speed” button to select wind speed.
Heating operation (this function is not available for a cold-single unit)
● Press the “Mode” button till the “Heat” icon appears.
● Press the “ ”or“ ” button to select a desired room temperature. (62-90F0)
● Press the “Fan Speed” button to select wind speed.