North Storm NS-10W-AC User Manual - Operation Introduction Cont.
11
Timer operation
Timer ON setting:
● When the air-conditioner is OFF, press the “Timer” button and select a desired
ON time through the temperature and time setting buttons.
● “Preset ON Time” is displayed on the operation panel.
● ON time can be regulated at any time in 0-24 hours.
Timer OFF setting
● When the air-conditioner ON, press “Timer” button and select a desired OFF time
through the temperature and time setting buttons.
● “Preset OFF Time” is displayed on the operation panel.
● OFF time can be regulated at any time in 0-24 hours.
Drainage
Internal Tank Water Full Alarm Function
● The inner water tank in the air-conditioner has one water level safety switches, it
controls water level. When water level reaches an anticipated height, the water
full indicator lamp lights up. (If water pump is damaged, when the water is full,
please remove the rubber blockage at the bottom of unit, and all water will
drain outside.)
CONTINUOUS DRAINAGE
● When you plan to leave this unit unused for a long time, please remove the
rubber blockage from the drainage hole at the bottom of unit, and connect a
drain hose to the lower fixing clip. All the water in the water tank will
drain outside.
● You can drain the water as the above when the unit working at the HEAT mode.
● If water pump is damaged, continuous drainage can be used, and under this
condition, the water pump is not activated. The unit can also work well.
● If water pump is damaged, intermittent drainage can also be used. Under this
condition, when the water full indicator lamp lights up, please connect a drain
hose to the lower fixing clip, then all the water in the water tank will drain
outside. The unit can also work well.
OPERATION INTRODUCTION CONT.
12
INSTALLATION EXPLANATIONS
Installation Explanations:
● A removal air-conditioner shall be installed in the flat and empty place all
around. Don’t block the air outlet, and the required distance around should be
at least 30cm. (See Fig.7)
● Should not be installed in dry cleaner.
● Socket wiring should be in accordance with the local electric safety
requirements.
I
ntroduction to Exhaust Hose Installation
Temporary installation
● Twist both ends of the exhaust hose into the square fixing clip and the flat
fixing clip.
● Insert the square fixing clip into openings at back of the air conditioner
(see Fig.8).
● Put the other end of the exhaust hose to the near windowsill.
FIG. 7
FIG. 8
Drain Hose
30 cm
30 cm