Northern Lights OWN-GEN Installation And User Manual - page 23
OWN-GEN 01/12
21
There are 3 main display pages for remote unit: the REMOTE UNIT SETTINGS page, ON-LINE GENSET
STATUS page and ON-LINE GENSET PARAMETERS page. When the WaveNet Remote unit powers on,
it will go to the ON-LINE GENSET STATUS page.
The 3 main line positions display the current available on-line genset controllers. Each line displays the
on-line Genset Controller’s Name, State and the Status Mark. On the second line of the display, the
relevant message of the selected genset controller, like warning, running detail etc., is shown.
7 WAVENET REMOTE PANEL
Access this mode by pressing the Info key from the ON-LINE GENSET STATUS page. Press Info or hold
Stop to return to the ON-LINE GENSET STATUS page.
On the REMOTE UNIT SETTINGS page, there
are 3 settings menus. The Clock Setup, Basic
Setup and Advanced Setup will allow the user
to change various WaveNet Remote panel settings.
Clock Setup - Allows the user to adjust current
real time like year, month, week, day, hour,
minute and 24/12 display format.
Basic Setup - Allows the user to adjust the LCD
display contrast, on-line genset message update
speed, parameters page scrolling speed and
status page backlight shutdown delay.
Advanced Setup - To go into this menu, the user needs to input the password. The default password is
0000. Within Advanced Setup there are 3 sub-menus, Networking, Set Units and Set Password.
In Networking, the user can enlist the WaveNet Remote to on-line genset controllers. This will Enable or
Disable the WaveNet Remote unit to start and stop a genset. The user can also edit the Genset On-Line
Timeout Delay. If the Genset On-Line Timeout Delay elapses for an on-line genset without receiving
an update from the local WaveNet panel the remote unit will remove that genset from the list of on-line
gensets. (Note: “-----” indicates the lack of an on-line genset controller. The ability to enable or disable
selections on these “-----” names is unavailable.)
In the Set Unit sub-menu, users can set the WaveNet Remote panel to display the temperature in
Fahrenheit or Celsius, and the pressure in KPa or PSI.
In Set Password the user can change the Advanced Menu access password, the default password is 0000.
7.1 REMOTE UNIT SETTINGS
7.2 ON-LINE GENSET STATUS MODE