Flat wall mounted / free stand electric fireplace model numbers: 80-421s owner’s manual wall hanging mode freestanding mode ac 120v / 60hz 1500w warning read and understand this entire owner’s manual, including all safety information, before plugging in or using this product. Failure to do so could ...
2 important safety information! Warning read all instructions before using this heater! This heater is hot when in use. To avoid burns, do not let bare skin touch hot surfaces. If provided, use handles when moving this heater. Keep combustible materials, such as furniture, pillows, bedding, papers, ...
3 warning for residential use only! Not for commercial use! Any commercial or public use of this heater voids all warranties, and could cause injury. This product is not intended to be a primary heat source. It is for supplemental heat only. Indoor use only! Never use this heater outdoors! Doing so ...
4 the power cord supplied with the heater has three prongs: two flat blades (live and neutral) and one round pin (ground). If a 3-slot receptacle is not available, an adapter must be used. The adapter must be properly grounded to the outlet box (see figure at right). [note: adapter not included.] sa...
5 installation and assembly rear view of fireplace step 1. Find a safe location. Minimum clearance on each side: 19.7” (50 cm). Minimum clearance below: 19.7” (50 cm). Minimum clearance above: 39.4” (100 cm). Minimum clearance from the front and sides: 19.7” (50 cm). Choose a location near an outlet...
6 c.
7 step2 ) using the three wood screws (b) to fix the wall bracket , with wood screws thread the wall bracket and to lock with the drywall anchors, please tighten all wood screws. Step 3) have two people lift the fireplace machine up and insert the hooks ( 2 hooks on back of fireplace box) to the wal...
8 step 4) with the fireplace installed safely, then using screws driver to lock the bracket and fireplace with two st4x10 (d) screws in both sides.Check the appliance for stability ensuring that the appliance will not pull free from the wall. St4x10 2 (pcs) d a.
9 installation for pebbles.
10 note: to install decorative pebbles, follow these steps. Have a capable adult help you. Step 5a. While one person holds the glass panel, remove the two screws at the top edge of the fireplace with a phillips (+) screwdriver. Step 5b. Together, carefully remove the front glass panel and set it asi...
11 pages 2 and 3). Make sure the outlet is in good condition and that the plug is not loose. Never exceed the maximum amperage for the circuit. Do not plug other appliances into the same circuit. Methods of operation this electric fireplace can be operated by the control panel, located on the right ...
12 flame + flame “+”: makes flame effect brighter. Note: flame effect stays on until power button is turned off. Flame effect must be on for heater to turn on. 1. Press once. Flame effect gets brighter. 2. Press again until desired setting is reached. Flame effect continues to get brighter each time...
13 always turn the heater off and unplug the power cord from the outlet before cleaning, performing maintenance, or moving this fireplace. Failure to do so could result in electric shock, fire, or personal injury. Never immerse in water or spray with water. Doing so could result in electric shock, f...
