Northwest 80-421S Owner's Manual - Operation
10
NOTE: To install decorative pebbles, follow these steps. Have a capable adult help you.
STEP 5A. While one person holds the glass panel, remove the two screws at the top edge of the
fireplace with a Phillips (+) screwdriver.
STEP 5B. Together, carefully remove the front glass panel and set it aside on a clean soft surface.
STEP 5C. Set the plastic shelf (H) onto the ledge in the opening at the front of the fireplace.
STEP 5D. Arrange the decorative pebbles (F) on the plastic shelf in the desired position.
STEP 5E. Set the front glass panel back onto the firebox.
STEP 5F. Align the tabs of the glass panel with the holes on the top edge of the fireplace. Thread
the screws back into the holes and tighten them both with a Phillips screwdriver.
Installation for Metal Stand
STEP 6A.Fix the J1 and J2 metal parts with screws ( I ) , in total two sets. Using screws (D) to fix
the two stand brackets (G) to the J1/J2.8pcs screws (D) will be used.
STEP 6B.Put the fireplace on a soft surface flatly,see the drawing above,locate the bracket to the
bottom mounting holes,fix the baseboard with 8pcs ST4x10 screws(D)
Tighten each screw securely with a Phillips screwdriver.
Operation
Read and understand this entire owner’s manual, including all safety information,
before plugging in or using this product. Failure to do so could result in electric shock,
fire, serious injury, or death.
Power
Make sure the ON/OFF switch, located on the left side panel, is in the OFF position. Plug the power
cord into a 110~120 Volt 15 Amp grounded outlet (see IMPORTANT SAFETY INFORMATION on
J1/J2
I
D
G
D