Northwest 80-421S Owner's Manual - Preparation
4
The power cord supplied with the heater has three
prongs: two flat blades (live and neutral) and one
round pin (ground). If a 3-slot receptacle is not
available, an adapter MUST be used. The adapter
MUST be properly grounded to the outlet box (see
figure at right). [NOTE: Adapter NOT INCLUDED.]
SAVE THESE INSTRUCTIONS!
Preparation
This product includes a GLASS panel! Always use extreme caution when handling
glass. Failure to do so could result in personal injury or property damage.
Remove all parts and hardware from the carton and place them on a clean, soft, dry surface. Parts
and assembly steps are grouped for free-standing or wall-hanging use. Check the parts list to make
sure nothing is missing. Dispose of packaging materials properly. Please recycle whenever possible.
You will need the following tools (not included): Phillips screwdriver; stud finder; level; tape
measure; electric drill; ¢7 wood drill bit, hammer.
Parts and Hardware
A – Fireplace ( 1 )
B – Wood Screws ( 3)
ST5×37mm
C – Drywall anchors ( 3 )
Ø7×37mm
D – ST4x10 Metal Screws
(18)
RC – Remote Control
E - Wall Bracket (1)
F-Pebbles (1)
G – Stand Bracket ( 2 )
H – Plastic Shelf (1)
I – M6x15 screws for Stand
bracket (4)
J1 (2) / J2 (2)- Metal parts for
stand