Novag TOURMALINE Instruction - To Add:
14
The procedure is as follows:
Press "FP/EP" key twice. The display will show "EP – –", you are now in the EP
= ENTER mode. If you now merely wish to alter a position by adding pieces or
deleting pieces proceed as follows.
A.
To Add:
1.
Select the colour ("G7") of the piece.
2.
Select the piece by using keys "A1" through "F6".
3. Select the letter and number of the square corresponding to the position
on the board.
4.
Repeat for each piece/position desired.
5.
Press ENTER to exit the EP mode to begin to play.
Example:
To create a White Rook on square C1. Press "G7" key to select the colour for
White, then "D4" for the Rook and "C3" followed by "A1" for the square.
The display will show "
r c1". You can tell the computer about all the
other pieces with choosing Black/White and piece symbols independently until
your position is complete. To exit this mode press ENTER. We recommend to
verify your set-up position before you start to play.
B.
To Delete A Piece:
In the EP mode press CLEAR key then use the keys "A1" through "H8" to
address the square you wish to clear.
Example:
To clear square C7 press always CLEAR key then "C3" and "G7". The display
will show " c7" indicating no piece on C7. Press ENTER to exit the EP
mode to begin to play.
Note: For a single piece you do not have to specify the type or colour of the
piece deleted, simply enter the letter and number co-ordinates
associated with the square on which the piece stands. Repeat for any
additional pieces to be deleted.
C.
Clearing The Board:
In the EP mode press CLEAR key. You see "
– – ". When this display is
showing, you have to press CLEAR once more to clear the entire board and the
display will show "EP – – " again.