Ethernet ® adapter installation instructions doc. #569040000—a 7/30/04 printed in u.S.A..
Disclaimer logic one ® is a registered trademark of novar controls corporation. The material in this manual is for information purposes only. The contents and the product it describes are subject to change without notice. Novar controls corporation makes no representations or warranties with respect...
Description the ethernet ® adapter module (model ep/2-ea) is connected to novar controls’ executive processor 2 (ep/2) to allow the ep/2 to communicate over a local area network (lan) that uses ethernet hardware and software. The ethernet network provides the capability for multiple ep/2s, novar con...
Note! The knockout hole on the left side of the ep/2 baseplate will be blocked by the ethernet adapter. If wires run through this hole, they must be rerouted. Do not route them under the adapter. The ethernet adapter must sit firmly against the baseplate to ensure a proper connection. Use the follow...
Step procedure 4 align the adapter’s three mounting holes with the three mounting posts (shown in figure 1) and carefully push the adapter toward the baseplate. 5 insert the three 1-inch screws included with the mounting kit (see figure 2), making certain that they are aligned correctly, and tighten...
Step procedure 4 use the hex wrench to tighten the retaining screw in the mounting post on the right side to secure the ep/2 electronics assembly to the baseplate. § the left retaining screw cannot be used with the ethernet adapter installed. Checking installation to check the installation, monitor ...
