Novar EP/2-EA Installation Instructions Manual - page 3
Description
The Ethernet
®
Adapter module (Model EP/2-EA) is connected to Novar
Controls’ Executive Processor 2 (EP/2) to allow the EP/2 to communicate over a
Local Area Network (LAN) that uses Ethernet hardware and software. The
Ethernet network provides the capability for multiple EP/2s, Novar Controls
workstations, and other devices to communicate with each other across the
network. By communicating with an EP/2 through Ethernet, any properly
configured personal computer can access real-time, online data from the Logic
One
®
system.
The EP/2 requires a PROM level of 18.20 or greater and a download version of
18.20 or greater to use the Ethernet Adapter.
Specifications
Operating Environment
Temperature:
32° to 140°F (0° to 60°C)
Humidity:
0 to 95% Relative, noncondensing
Physical Dimensions
Height:
7 inches
Width:
3.63 inches
Depth:
1 inch
Weight:
8 oz (All aluminum enclosure)
Precautions
Observe all national and local electrical codes during installation.
Mounting the Ethernet
Adapter
CAUTION! Remove the EP/2 electronics assembly before
mounting the Ethernet Adapter to the EP/2 baseplate.
The following items are needed for installation:
§
Ethernet Adapter
§
Three 1-inch screws (included with the adapter’s hardware kit)
§
A twisted-pair, Ethernet-compatible cable (10Base-T) with an RJ-45 connector.
The adapter should be mounted inside the EP/2 baseplate enclosure, to the left of
the EP/2’s transition board (see Figure 1).
NOTE! Complete the installation procedures in the order they are
presented in these instructions. Varying from these
instructions could result in damage to the Ethernet Adapter
and/or the EP/2.
Doc. #569040000—A
7/30/04
1
Ethernet
®
Adapter Installation Instructions