Novar Savvy Service Manual - page 6
Step
Procedure
4
Loosen the two retaining Allen screws used to mount the
electronic assembly to the Savvy baseplate (see Figure 2).
5
Push the assembly straight up off the base.
6
Slide the replacement electronics assembly down from the top of
the baseplate assembly, over the mounting posts, guiding the
DB25 and DB37 connectors over their connectors on the
transition board.
7
Tighten the two retaining Allen screws to secure the assembly.
8
Reconnect the Ethernet cable, if applicable.
9
Perform a program download, if needed, and verify that the
equipment is operating properly.
10
Set all lighting HOA toggle switches to the AUTO position.
11
Return the Savvy’s bottom cover and tighten the screws to secure it.
Figure 2. Location of mounting screws on a Savvy electronics assembly
6
DOC. #TD-0240 11/30/06
Savvy
®
Service Manual
ALLEN SCREWS
LOCATED ON BOTTOM LIP
OF ELECTRONICS BACKPLATE
Allen screws used to mount
the electronics assembly to
the baseplate can be found
on the bottom edge of the
electronics backplate.