NovaSail NS100 Operating Manual - Cog
NS100
Operating Manual
9
A short press on
starts the downcounter.It can be re-adjusted to 5/4/1
minutes by a long press on
, whether it is stopped or still running.
When the timer reaches 0:00 it will start upcounting (’TIM up’) and will indicate the
time elapsed (hours/minutes).
Note
:
When the timer reaches 0:00, the display will automatically switch to the
main screen mode (unless the MOB mode is already engaged).
A short press on
will stop or restart the downcounter. To reset the timer
and restart in downcounting mode, a long push must be applied on
when
the timer is stopped.
Note
:
In downcounting mode, the timer will emit a beep every minute; every 10
seconds below 1 minute, every second below 10 seconds.
COG
, lower line: The course over ground as measured by the GPS receiver is
displayed. The value displayed can be averaged; see “GPS Heading sensitivity:
COG”, page 14.
GPS coordinates
This mode provides the current GPS coordinates as measured by the GPS
receiver (degrees/minutes decimal).
Maximum speed and total distance
This mode provides the maximum speed recorded and the total distance.
SPM
, upper Line: Speed Max
The maximum speed is displayed in knots (KT). This value is saved when the
device is turned OFF. It can be reset by pushing the
button.