Oasis OASIS-30 User Manual - page 9

5

1310836-07 | Mar 02 2016

ADDING OR REPLACING THE ARTWORK IN THE 

HEADER OF THE UNIT

1

Power off & unplug Oasis unit

2 

Remove top three screws at the back of the unit ▼

2

3

 Remove the header frame ▼

4 

The artwork is sandwiched between two sheets of 

plastic. Use a knife or box cutter to cut the tape holding 

the two sheets together. ▼ 

5 

Lift the top sheet, remove the artwork and replace it. ▼

 x x

6 

reassemble: replace the  tape along the edges of the 

plastic sheets & secure the header frame with the three 

screws.

APPLYING DECAL GRAPHICS ON GLASS

1

 Wet the glass and the sticky side of the graphics with 

soapy water (a small amount of soap diluted with water in 

a spray bottle, or use Windex)

2

 apply the graphics. The soapy water allows you to move 

them around on the glass until they are in the proper 

position.

3

 Use a squeegee or a malleable straight edge to remove 

all excess water and air bubbles beneath the graphics.

4

 Once dry, verify that the edges of the graphics are 

properly glued. Give the edges a final press if needed. 

Installation