Oasis P1PV Installation & Service Instructions Manual - page 10
P1PV / P1PVCD Series
Installation & Service Instructions
030099-347 Rev. 2
pg 10 of 16
© Copyright 2007 OASIS Corporation
Connecting Water Cooler to Water Supply:
All OASIS POU water coolers are supplied with a push-fit connector that should be used to connect the
cooler to the water supply. Tri Palm International recommends that these guidelines should be followed
when installing the cooler:
Use ¼” diameter tubing to connect the water supply to the water cooler. Although 6 mm tubing will
appear to fit, it is approximately 5% smaller in size. The use of 6mm tubing will result in a leak.
A pressure regulator, such as a slow flow regulator, must be installed in front of the unit’s water inlet if
the water pressure (including any possible pressure spikes) could exceed 690 kPA (100 psig.). Failure
to comply will void the warranty. The manufacturer accepts no liability for damage caused by excessive
water pressure.
Installing the water cooler at your customer’s premises:
1.
Carry the cooler in the upright position to the customer’s premises - use the handle at the rear of
the unit.
2.
Remove the shipping bag from the cooler.
3.
Carry out a general inspection of the cooler, ensuring that :
a)
There are no marks or physical damage to the cooler.
b)
That all accessories are present.
c)
That all the wires and electrical connections are in place at the back of the cooler.
d)
That the cooler is clean and dust free.
e)
Sit the machine as close to the electrical and water supply as possible with a 50mm (2”) air gap
at both sides and back of the machine. Mount the machine on a firm flat surface so that it cannot
topple over. Please remember that the machine should not be exposed to direct sunlight or heat
sources above 32°C (90°F).
f)
It is advisable that the water supply and electrical supply be within 2 meters (6 feet) of the
machine for ease of installation.
g)
Level the machine using the adjustable feet.
6.
Connect the water cooler to a potable water supply.
7.
Inspect the electrical socket, the machine plug and the power cable for any transit damage. Make
sure the hot tank switch is off, then plug the power lead into the back of the machine. As soon as
you plug the machine into a suitable power supply, you can start to flush water through the
machine.
8.
Press both buttons on the front left to dispense hot temperature water, if applicable, and keep the
buttons depressed until the water from the outlet runs clear – note that it will take some time to
bleed all of the air from the hot tank.
9.
Press the dispensing water for ambient temperature water, if applicable, and keep the button
depressed until the water from the outlet runs clear.