Oasis P1PV Installation & Service Instructions Manual - page 13
P1PV / P1PVCD Series
Installation & Service Instructions
030099-347 Rev. 2
pg 13 of 16
© Copyright 2007 OASIS Corporation
Cleaning and Sanitizing Instructions:
This procedure should be used for initial cleaning prior to installation and also for on-site sanitization.
The diagram below illustrates the water circuit used in all PV-DC model coolers:
No
230V
115V
Description
1
028913-002
028913-002 JG FITTING, BULKHEAD CONNECTOR
2
029959-002
029959-002 TUBING, 1/4"
3
029199-003
029199-003 JG FITTING, TEE PIECE, 1/4"
4
034277-002
034277-002 JG FITTING, 1/4" BSP
5
034613-001
034613-002 SOLENOID VALVE 230V
6
030552-101
030552-101 JG FITTING, 3/8" TO 1/4" REDUCER
7
028672-001
028672-001 CARTRIDGE, HALF SET
8
035351-002
035351-002 CHECK VALVE
9
034663-001
034663-001 WATER OUTLET MOULDED
10
034625-001
034625-001 SPOUT, WATER OUTLET
11
034506-001
034506-001 COOLING TANK, HEAD
12
030858-407
030858-407 O-RING
13
034507-002
034507-002 COOLING TANK, BASE
14
034782-001
034782-001 DRAIN TUBE, 3/8” OD
15
034361-001
034361-001 DRAIN VALVE ASSY
16
036033-001
036033-001 HOT TANK HEAD
17
036134-001
036134-001 HOT TANK BASE
18
032487-004
032487-003 HEATING ELEMENT
19
028768-101
028768-101 JG FITTING, 3/8” ELBOW
20
034734-002
034734-002 TUBING, 3/8” OUTLET/VENT
Equipment:
•
Household bleach (5% sodium hypochlorite)
•
Mild soap solution
•
Plastic bucket
•
One 12” length of ¼”OD plastic tubing
Preparation of Filter Cleaning Cartridge:
•
In order to get cleaning solution into contact with all of the water-contact surfaces it is
recommended that you prepare a filter cleaning cartridge. This should consist of an empty
filter housing and head assembly (i.e. does not contain a filter media).
•
To prepare the cleaning cartridge, place 1 ml (1/4 tsp) of the sodium hypochlorite solution into
the empty housing and then re-fit the head
Sanitization Instructions:
•
Temporarily disconnect the water cooler from the water supply
•
Remove the front door and the top from the cooler. If no filter has been installed in the cooler,
disconnect the blue tubing from the tee that connects to the bulkhead fitting on the back of the
cooler. Connect it to the inlet side of the filter cleaning cartridge.
o
Note: If a filter system has been installed in the cooler, use the filter cleaning cartridge to
bypass the filter system (i.e. disconnect the tube attached to the inlet of the filter system
and fit it to the inlet of the filter cleaning cartridge)
•
For coolers with no filters in them, use a 12” length of ¼” blue tubing to connect the outlet
side of the filter cleaning cartridge to the tee. If filters are installed in the cooler, you should