OBH Nordica 5579 Manual - page 20
20
OBH Nordica Rechargeable hair clipper
Before use
Please read the instructions carefully and safe them for future use before using for the appliance
for the first time.
Make sure that the appliance is fully charged before use if you should use it without adaptor.
Parts of the appliance (see page 3)
1. Trimming head
2. Adjustment knob for cutting length
3. Setting knob for thinning tool
4. Switch
5. Adapter
6. Charging station
7. Comb attachments + thinning attachment (not all shown)
8. Storage pouch
9. Scissor and comb
10. Oil
11. Cleaning brush
12. Cape
Recharging:
1. Place the hair clipper in the charging station and connect the adapters connecting plug to
the charging station.
2. Plug the adapter to an outlet, the charging indicator lights.
3. Make sure that the appliance is shut off during charging.
Let the appliance recharge for at least 16 hours the three first charging processes. After that you
can recharge for appr. 10 hours if the batteries are run down. With fully recharged batteries you
can run the appliance cordless for about 50 minutes (depending on your hair type/length).
How to use the appliance with adapter
Connect the adapters connecting plug to the appliance and plug the adapter to an outlet. Make
sure that the appliance is shut off when connected and wait a second before you start it (if
the appliance does not start immediately, recharge it for appr. 1 minute). Make sure that the
appliance is shut off during recharge.
Use
Make sure that the appliance is clean, fully recharged or connected to the adapter and
•
ready to use. Make sure to oil the cutting blade regularly to maintain a good performance
(see further under “Cleaning and maintenance”).
The hair should be washed, combed and dried (wet hair will make it harder to pass the
•
comb through the hair).
Choose the comb attachment that corresponds with the length you want on your hair
•
(4-6 or 18-30 mm). It is recommended that you start with the longest comb the first time
to prevent cutting of too much. The measurements are marked on the combs. A thinning
comb is also included if you just need to thin out your hair.
Press the comb attachment to the trimming head and make sure that it clicks into the
•
notches on each side of the appliance. The appliance can also be used without combs if
you want a shaved result (see further under “Use without comb attachment”.
5579_AE_0509.indd 20
2009-07-10 17:12:59