Océ PP20D Operation Manual - page 15

Operator Panel

1-5

1 — Software Version

This information shows the software (firmware) version and date of issue 

of the printer.

2 — Hardware Information

This information shows the currently selected paper source (indicated by 

an asterisk), paper size, and various other printer settings.

3 — Page Information

This information shows the currently selected resolution, number of copies 

printed to date, and the total page count.

4 — Network Status

This shows the IP address, subnet mask address, default gateway address 

and other settings for the network interface card installed in the printer.

5 — Memory

This information shows the amount of total memory installed in the 

printer, the amount of currently available memory, and the current status 

of the RAM disk.

6 — Installation Options

This shows the option(s) currently installed in the printer.

7 — Emulation

This shows all available emulations and the currently selected emulation 

(marked with an asterisk). The printer is shipped from the factory with 

PCL 6 emulation selected.

8 — Error Log

This shows the last three instances of the following six types of errors, 

listed in order of occurrence: KPDL Error Press GO; Memory overflow 

Press GO; Print overrun Press GO; File not found Press GO; 

MemoryCard err Press GO; RAM disk error Press GO. (These are 

displayed on the computer screen when using KM-NET for Clients.)

The most recent error is displayed on the top line of the Error Log. For 

error remedies, see 

Chapter 3

. Error information is cleared when the 

printer’s power is turned off. 

9 — Toner Gauge

This shows the approximate level of remaining toner. When the value is 

100, the toner container is full. The closer to 0, the smaller the amount of 

remaining toner.