Oce PlotWave 350 User Manual - page 8
•
Do not use any power cable other than the one provided. Never use the power cable
with any other electrical device.
Power source
Warning
•
Put the power plug directly into a wall socket that has the same configuration as the
plug. The use of an adapter leads can result in an inadequate power supply. If a
proper wall outlet is not available, ask a qualified electrician to carry out the installation.
•
Do not connect the machine to a mains voltage that differs from the value as stated
on the power marking label.
•
Do not use a multiple outlet adapter or an extension lead. Contact your authorized
service representative if an extension lead is required.
Caution
•
Consult your authorized service representative before you connect other equipment
to the same wall outlet.
Note
•
If connection to a different mains voltage is required, contact your authorized service
representative.
Power plug
Warning
•
For machines that are connected via a wall socket: Place the machine close to a wall
socket that is easily accessible. The power plug is intended to serve as a disconnect
device.
Grounding
Warning
•
Connect the power cord to an electrical outlet (wall socket) that is equipped with a
grounding terminal.
•
This equipment has not been designed for connection to an IT power system. An IT
power system is a voltage network in which the neutral wire is not connected to ground.
Installation
Warning
•
Make sure that the machine is placed on a level, horizontal surface of sufficient strength.
•
Do not place this machine on an unstable or tilted surface.
•
Do not place this machine in a location that is subject to lots of vibrations and shocks.
•
Do not use flammable sprays, liquids or gases near this product, because this could
cause a fire.
Chapter 1 - Instructions for safe use
8
Instructions for safe use