Ocean Signal V100 User Manual - Safesea V100 User Manual
3.11
Scan
Press and hold the SCN key until a double beep is heard.
The radio will now start scanning all the channels in the
radio for a signal.
To exit scan mode, press the SCN or key.
Often a channel will appear to exhibit a permanent signal or
is frequently used for traffic that is of no interest. In this
case when the scan has stopped on the channel,
pressing and holding the SCN key until the double beep is
heard will inhibit the channel from being scanned.
3.12
Memory Scan
To enter the Memory Scan mode, press the SCN key. The
radio will now start scanning only those channels that are
entered into the scan memory for a signal.
If there are no channels already entered,
pressing this key will have no effect.
To exit the Memory Scan mode, press the SCN or key.
3.13
Scan advance
In any of the scanning modes, if the radio has stopped on a
busy channel pressing the
key will recommence
scanning. NOTE: If the received signal on a busy channel
ceases, then the radio will automatically recommence
scanning after the set Scan Dwell Time (see section 4).
3.14
Setting Scan Channels
In the normal radio mode, it is possible to set scanning
options for each channel.
To enter channels into the scan memory, select the required
channel and double press the SCN key. The
legend will
appear on the LCD to indicate this channel is in the scan
memory. If the channel was already marked as a Memory
Scan channel, this operation will remove it from the scan
memory and the
legend will disappear.
10
SAFESEA V100 USER MANUAL
Part No. 912S-00957
HOLD
(double beep)
PRESS x 2