Oceanic 4141 User Manual - Installation
INSTALLATION
2
3 of 13
2.1 UNPACKING THE BOX
You will find the following items in the shipping box:
1 x iDACS display
1 x DC Power cable
1 x Bag containing 4 thumbwheel nuts & 4 sprung washers
1 x User Manual (This Document)
1 x Mounting cut out template
2.2 MOUNTING THE UNIT
1. The unit should be mounted through a panel to a flat surface.
2. It can be mounted 45 degrees either way of vertical.
3. There should be adequate ventilation around the product to prevent heat build up.
4. Remember to allow enough clearance for access to cables and connectors.
5. Using the 4 mounting studs and thumbwheel nuts, to secure the unit.
6. The unit should be sealed to the mounting surface using silicone sealant. This
silicone sealant will be part of the seal used to provide the IP rating for the product.
Once the cut-out and mounting holes have been created in the substrate, carefully slide the
unit into the cut-out, then from the other side fit the sprung washer & four thumbnuts and hand
tighten.
Side view showing outline.