Octava HDMX44-V1.3 Installation Manual - page 8
Basic Quick Start:
Use the remote control to select the Display that you wish to control
followed by the Input (DVD, Settop) that you wish to watch.
For example:
-Pressing Display B, “2” will switch Input 2 to HDMI Out B.
-To connect DIPLAY A to IN1 and DISPLAY B to IN3 you simply follow
this sequence
Step 1) Display A, 1 (this will set Display A to Input 1)
Step 2) Display B, 3 (this will set Display B to Input 3)
Here are some more examples:
RS232 Controls:
The Octava 4x4 HDMI Matrix Switch can be easily integrated with
3
rd
Party control systems via RS232 control. The following shows
the control protocol for controlling the HDMX44.
Baud rate=9600
Data bits=8
Parity check=None
Stop bits=1
Flow Control=None
Controlling the HDMX44 via RS232 can be done by send a series
of commands per the RS232 Command Table.
Protocol:
Example 1:
To Turn OFF the LED
Command =
Example2:
Switch Output C to view Input 3.
Command =
Note:
Output Selection
(Step 1)
Input Selection
(Step2)
Result
DISPLAY A
“2”
Display A switches to
Input 2
DISPLAY B
“1”
Display B switches to
Input 1
DISPLAY C
“2”
Display C switches to
Input 2
DISPLAY D
“1”
Display D switches to
Input 1
DISPLAY A
“+”
Display A increments to
next available Input
DISPLAY B
“-”
Display B decrements
to next available Input
DISPLAY C
“+”
Display C increments to
next available Input
DISPLAY D
“-”
Display D decrements
to next available Input
7
8