Octava HDMXA71-V1.3 Installation Manual - page 4
3
12
Configuring Smart Scan
TM
:
The Smart Scan is disabled before shipment. It is recommended
to leave Smart Scan disabled in most applications.
To enable the Smart Scan
TM
1) Set the Configuration switch #1 to the up position.
2) Re-power the matrix.
To disable Smart Scan
TM
1) Set the Configuration switch #1 to the down position.
2) Re-power the matrix.
Description:
Are you looking to route HDMI and 5.1/7.1 LPCM Audio to your
existing Surround Sound System? This unique 4x2 HDMI switch
routes both HDMI and 5.1/7.1 LPCM (8ch.) Analog Audio. Perfect
for systems using PS3 which has internal LPCM decoding on
HDMI. The 4x2 can take the decoded LPCM from the PS3 and
convert to 5.1/7.1 (8ch.) Analog Audio for easy integration with
your high end 5.1/7.1 audio receiver/amp. In addition, an Auxillary
5.1/7.1 (8ch.) audio Input allows you to connect a second Analog
5.1/7.1 source to your surround system.
Changing EDID mode:
It is recommended to keep the EDID in the factory default MODE1.
If necessary, you may set to different EDID mode by following these
instructions.
Step Action
Notes
1
Set the Smart Scan switch
to OFF
2
Disconnect all sources
and display from Matrix
3
Set the Progam/Lock
switch #4 to “program
mode” ( down)
4
Set the EDID to the mode
desired.(MODE 2 shown.)
See page 11
for other
EDID modes
5
Reset Power to the Matrix
by disconnecting the
power and reconnecting
power.
.
6
The LED will now indicate
the EDID Mode that you
will program.(mode 2
shown)
LED “2” will
flash.
SCAN=ON
SCAN=OFF